FS: Autometer 87-93 hardtop dual 2-1/16 A-pillar gauge pod

[MFE]

Autometer dual gauge pod for 87-93 hardtops accepts 2-1/16 gauges.

Used for 3 months but better than new because it's easier to install, becuase not only is it undamaged and pre-drilled for use with your factory A-pillar trim screws, I'm including the actual factory A-pillar trim it was attached to in the shipped sale price of $45 to the lower 48.

It would cost you almost that much to get just the pod shipped to you new from Summit, except in this case, you don't have to bother drilling it or cutting your factory trim. All you need to do is remove your factory A-pillar trim, install mine in its place, install your gauges, and fasten the pod using two of the factory screws for a clean, factory-installed look. I located the pod as low as possible on the A-pillar trim for neat unobtrusive appearance, while still allowing the dash speaker grille to be removed and replaced with no fuss, without removing the pod or the A-pillar trim.

In short, this is a fully thought-out plug&play install. Yours for $45 shipping included anywhere in the lower 48. I also accept paypal.